Search results

I used a CERAKOTE Ceramic Headlight Restoration Kit off Amazon. It lasted a year and has started to cloud a little bit on the top surface. They are sending me a free redo kit. So didn't last as long as I would like but good customer service.

bamwholesaleparts seems to have the best prices I could find.

Just an oil change today. Then I ended up putting the original lower motor mount back on. The one I put on 16k miles ago was already toast.

I have been happy with them. They are Monroe original ride quality. Handles like new. If I want sporty I will drive my Miata.

My solution was quick struts. Got them from Rock Auto. Less than $10 a side more than struts top mounts and boots separately. And I got new springs.

There is a hook on the pivot side, opposite side from the key hole side, that breaks of and lets the handle move do it can't go back down fully. I had the issue and just kids replaced the handle. For the back passenger side, a drivers side from a non sliding door will work. I got a back...

Check all of your grounds?

With the excess room behind the engine I've always thought a V6 would fit.

I would think you need a replacement transmission.

How about a speed 3 swap?

I got a white handle at pick n pull. My 5 is red. It was a safety issue because some times it would not keep the door closed. It was $20 or so. I keep an eye on eBay, CL, and parts places for one in my color. No hurry as I'm not selling it anytime soon. And it is on there passenger side and I...

I know ABS melts for 3d printing close to 400 but I would keep closer to under hood temps to avoid damage. Your range sounds safe.

Yes, sometimes. I figured out it was related to the outside handle not going all the way back in. If it would not latch when closing play with the handle and make sure it popped in all the way in.

I had a similar issue. The 'hook' part of the handle on the inside rear broke off. Door would not close if the handle did not get pushed back in properly. I went to pick and pull and got just the handle part and it resolved my issue. Just need to get it painted to match.

I did quick struts. The cost was a few $ more than strut and top mount. Well with the $7 or $8 total extra.

Find/buy an ozone generator. Close it up on the car a couple of nights. I did this with a Miata someone smoked in and it helped a lot.

I put a replacement carpet in my Miata. I hung it on a fence and sprayed it with hose until the water ran out clean and let it dry before I put it in. It you are pulling the carpet anyway you could give washing it a try first.

I used trackmotive from RockAuto last year. I've only put about 5k miles on them but I have not had any issues so far. I have a manual transmission, too.

Below is the kit I got from RockAuto. It shows other applications it fits.