Search results

On your computer. When you updated the SD card, the first thing that happened was the creation of the back-up file.

You nailed it, @sm1ke ! The bolt on route seems more appealing to me precisely because I don't want to cut any pipe.

I don't have a local shop and I'd imagine that it would cost more than 600$ to just go to some shop and ask them to make an axle back for my car, I don't know. Paying for one already built seems to me the easiest route.

I would try to drill a small hole on the side, somewhere and dry it through. Then seal the hole.But this is just theory, not sure if the plastic won't crack and then you would have to replace the headlight anyway.

I've looked at Borla and Corksport and I'm undecided. I find Borla really expensive.

V1! Rotate! 😆 Aerodynamics would be my last concern with a CX-5. Old thread but I stumbled upon looking for discussions about axle back exhaust! 😎

How did you improve the ground system? Added some bonding straps? Could you share some info on this? Maybe pictures? I'm thinking about adding some too.

I would check the canbus wire harness. Look for broken wires, inspect (visual inspection) the connectors for broken contact pins, bent pins, corroded etc. Do a pull test: gently pull the wires at the back of the connectors to see if any wire is broken or it's coming out of the connector. Look...

OK, checked it today again. It's a lot simpler than you think. Grab your fob, go to the car. Set the parking brake; Put the gear lever into P; Start the engine. Adjust your seat to your linking. Press Set button on the seat, you hear a beep; Press and hold the unlock button on your fob until...

On my car the seat it's not instantly set to the position memorized. It goes into the memorized position only when I open the door.

If I remember correctly: First, adjust the seat to your liking. 1. Press Set button, you should hear a beep. 2. After you hear the beep press and hold button no. 1 until you hear another beep. All set, the seat memorizes the settings. For your wife you can use button number 2 and repeat the...

See this post 2017~2025 How to reset Mazda Skyactiv transmission

The newer Mazdas, like CX- 5, CX-9 etc have electric steering and corrosion or poor connection between the battery and the cables leads to problems similar to yours. Clearly it's not the case in your situation. My apologies.

No stupid question is a stupid question so I am going to ask: Is your steering electric, like on the newer Mazdas? If the answer is yes, do you put dielectric on the battery terminals before connecting the cables?

Speaking about the freeway exit number, I've noticed that if you enable the audio guidance you DO GET the exit number AUDIO , in conjunction with the visual queue in the "Junction view" that pops up on the right side of the screen. IF you pay attention to the audio! 😆 If audio guidance is...

Installed gas struts for the engine bonnet. Redline Tuning Quicklift Elite with with black carbon sleeves.

Go on an official Mazda parts website. Have your VIN number ready and look for that mirror and check it against your VIN number. Better yet, go to your local Mazda dealership at the parts department and ask them to find your mirror part number.