Search results

Very nice. I've been a fan of those wheels. They make the car look so much better.

I need to do more work but this is what's done so far. More pics and progress as time goes on. Should be installed in about a month Spare VJ11 Unclip the wastegate Remove the 6 8mm bolts that hold the cold side housing/wastegate onto the center section Unbolt the 4 13mm bolts that hold...

Good to see you got it fixed. I've personally never had to lift the motor. Idk.

Have you removed the timing belt?I've done like 3 pumps and never had a problem when using just a haynes manual. It may be the ciltons manual messing you up since there's a bunch of different models displayed in theirs. Any way to snap a pic and I may be able to help you furthur

Thanks. ;) How about a mod make this a sticky? :)

As a person that was personally effected by Ryans prank(my grandmother is dieing of cancer) I can personally say that yes it hurt me and I was upset. When he said it was a joke I got steamed but then relaxed and then felt better knowing he is going to be ok. He is a good guy and an asset to the...

You sir have 1 sweet ride. ;)

Installation is reverse of removal Here is the remaining parts of the kit that are unused. Seems like a waste to buy the kit. I'm not sure if the stock sock fits the walbro pump but I figured just to use all new parts. The whole process took around 20-30 mins to do. Well worth it. I had a...

Installing the new pump onto the assembly Size up the new fuel line. This is the line that goes from the pump to the assembly. It's a little more than half. Yours may be different. Install the new clamp provided in the kit Slide the new pump onto the assembly and clamp the second part down...

Prepping the new pump Go ahead and take the end caps off and trash them. 1 on each side(brown and grey) Now take the new sock and slip it in place This little clip is provided in the kit as well Put it like this I used a very small socket and pushed it down The sock is now secured...

Removing the old pump from the assembly Loosen the clamps that hold the fuel line. Then remove this Philips head screw After removing the screw you can pull off this rubber piece and the rubber band and set them aside. You'll need to reuse this. Now go ahead and slide the old pump off...

Removing the fuel pump assembly De-pressurize your fuel tank. (I didn't like an idiot :cuss:) Remove the rear lower seat cushion. Disconnect the connector(Green) and unscrew the 4 Phillips screws(red) Lift the metal plate. Be careful as there's a 2nd connector and ground wire attached...

Mods if this is in the wrong section please move. I didn't see a how to section for the 1g. 1st you need the pump and install kit. Pump=gss315(255lph) Install kit=400-866(88-92 Probe/mx6) I got mine from jscspeed.com. Actually they are a vendor on here and since I am a member they gave a...

Damn you Joseph :mad: Just like my 1st 1g protege but without the whole drivers side smashed in lol

Now that's Mazda devotion lol

An older bf gtx that's running with rust usually goes for around 1000-2000. I wish you the best of luck finding 1. GTR on the other hand would be very costly. Importing 1 of those would probably be around 10-15k when said and done

Definetly let me know guys. She's getting a little bit of a bigger turbo soon. Not sure if I need this big of an injector but I'd rather be rich than lean ya know ;)

I was planning on about 8-9am. Be there around 11. Figured I'd slap some shine on the pro and ride.

I wont be riding along friday :( But will be there sat ;)