Search results

Racing beat rear swaybar and the AXR clunk fix kit , you wont regret it

If you cut a 1/2 an inch of the pipe where it goes into the intake it will clear the brake master cylinder no problem

One thing that no one mentioned is that with the codo as you pay it off you are getting equatity and with the student loan you have nothing , pay off the student loan first ,take the student loan payment add that to the mortgage payment and pay down the mortgage faster . The extra amount of...

I totally forgot about this thread

The inner boots dont usually tear , they will however wear out causing an off balance on the shift thus the vibration , they tend to go without much warning

Didnt I already say that . My 1st gen did the exact same thing it was the inner right CV joint that was starting to expire , I replace it with a remanufactured drive shaft rather than just replace the CV joint and now more noises ,vibrations .

Area 51 did the engine for the Wings West sedan ,from what i understand they couldnt getthe engine to run correctly ,I also read that Area 51 is no more

You may want to check the inner CV joints at the tranny . These will give those symptoms you are describing

Eye sight is one of the most important senses ,as you are now aware When I was 7 ,I was hit with a mudball in my left eye causing me to lose the sight in that eye , I can tell that being blind is no fun , I was that way for 18 weeks . You do learn to adapt ,to this day I can still sense things...

Its a tripod turn

Too cool now will it meet saftey standards .

Try a finer grit of sand paper , You are now going to have to take out the sanding scratches ,keep going finer and finer until you have the look you want ./ You can use water to help lubricate the sand paper as long as you use wet/dry sand papaer As for getting the scratches out you can use...

If you dont want the cats there use mothballs under the deck , Cats dont like the smell and when they piss the urine reacts with the mothballs and the cats hate that smell even more .

All you would have to do to make them fit is open the hole for the bar to 22 mm ,you can use sand paper to do that

PM sent

There is a resistor pack that is acting up I replaced mine and no more problems . I got one from a parts store rather than Mazda ,here is the info on the part The resistor came in a Standard box (brand name) the number on the box is a RU332 resistor . The UPC # 0 91769 61800 1 Hope this...

Can the orginal bumper be repaired ,if it can that may be the cheaper way to go

It gets worse , if you are caught speeding at 50 kph(30mph) over the limit your car will be imponded and crushed because you are racing . Persoanlly I think this has gone to far . It is time for the policy maker to take a hard look at all the deaths caused by crime ,DUI ,Poverty ,taxes...

That is great Laugh my ass off .

Somebody jump on this ,it is a super deal .