Search results

Ordered today also, Great deal @ $132

Mazda carplay/AA kit reduced to $155 including shipping on Ebay.

I have also found that I need to fill with 5.7 qts to get to the full mark. On my first oil change I did not check the stick after the change. 3,000 miles later I had the oil level light come on "not the oil pressure light". Oil was close to the lower mark. Needed to stop and add a quart. Not...

I lubed the brakes myself, took about an hour. Just wanted to see what was going on with my own eyes. I would assume that dealer would cover it, however they may consider it brake maintainence.

Had some squealing on our 2017 GT at 12k miles. Removed pads which had over 80% of pad left. Lubed everything and now they are quiet. Looked like pad was rubbing on the stainless hardware.

Look at pictures in my old post #12 here https://www.mazdas247.com/forum/showthread.php?123861007-Just-received-New-2018-CX-9-Info-from-Dealer

Only found 3 sets, Raybestos EHT1934H Monroe CX1259 AC Delco 17D1934CH

Thanks for the great write up, sure made it easy going. I used these bulbs from amazon. https://www.amazon.com/dp/B075K4DPFY/?tag=m20b7-20 Hope they last. They sure are bright!

Yes, Bumper cover chrome trim and minor damage to lift gate. Gate still functions normally. I was suprised at the total, had guessed about 1.5k but I was wrong.

Purchase 7/2017 Miles 6,000 Right at the 6 month mark, wife was rear ended. Everyone is safe and unhurt. Was hit by high school kid, his 2nd accident. Hope it looks good after repairs. $2,200 damage.

The drain tube for the A/C is plugged with dirt or fuzz. Need to locate the end of the drain tube under the car. It will be on the passenger side under the dash. Either fish up a wire through the tube, or blow out with compressed air. The evaporator will then fully drain. Saw your other...

Ok, you should be good to go then.

If the new resistor was run for any length of time (>2 min) without it being in its factory location it most likely damaged it. The factory location pulls air over the resistor to cool it. There is a thermal cut out fuse that would blow, inside the resistor if it reaches an unsafe temperature.

Here is the right one. http://www.ebay.com/itm/2006-2007-2008-Mazda3-Mazda6-CX7-CX9-RX8-Navigation-DVD-Map-U-S-Canada-Version-D-/302396736896?hash=item4668400580:g:lwgAAOSwK6RZFx8U&vxp=mtr

We got that one also, good fit and only $75 with ground shipping.

Did this mod yesterday with fiberfill and Dynamat of the outside. Sounds better but still a little boomey, but better.

Got this Maxliner for our CX9, Looks good with high lip, https://www.amazon.com/MAXTRAY-Weather-Mazxda-Behind-2016-2017/dp/B07338M13F/ref=sr_1_fkmr1_3?ie=UTF8&qid=1501434001&sr=8-3-fkmr1&keywords=Mazda+CX9+cargo+liner Fits fine but does not have protection for back of rear seats. You can get...

Agreed, There were just two there with distributor plates. Could have been added accessories, but not aftermarket.

This was at Mazda Corporate tech center, not at a dealer. Cars did not have window stickers. Look at Mazda pickup.