Recent content by Yoarashi

awesome, thanks guys

My amp does 200w @ 4ohm bridged or 100w @ 2ohm My new sub is a dual 2ohm voice coil The box interior wiring is a soldered single cable. My thought is to run the amp in bridged mode(200w 4ohm) and wire up the sub in series. So voice coil 1 + to amp + voice coil 1 - to voice coil 2 + voice...

I'm 100% in. Just did exhaust and motor mount. This and Forge bpv upgrade and im done.

Could you please post the mounted pics? Where is the amp going?

so tempted by the tmic but i just bought exhaust and motor mount...grr

I got em from tire rack no rubbing they are hyperblack which was a requirement for me, i just love that finish on a black car

Here they are 18x7.5 42mm on stock rubber. I will go 225/40/18 when these wear out

what the hell is the second stem hole for?

I have a black ms3 I've narrowed my choices down to the below. What do you guys think? Enkei NT03s Or 5Zigen Fn01r-c

got any pics?

the offset worries me, any opinions?

Thinking about going up to 18x8. Will the stock tires fit?

I just got 4 wheels and 2 seperate shops said they were out of round. Anybody else ever run into this? I personally have never and gone through many sets of wheels.

I have one. Yes you can use the steering wheel controls. Mine sits in the glove box but you could route the cable anywhere, its pretty long. No problems with alternator whine.

The xede unit is a interceptor type. It doesnt reflash anything. It intercepts the signals from the ecu and rewrites them and then sends them out. With the pnp harness its as simple as plugging it in. The unit comes with a base map that is pretty good but could be made much better if you...