Recent content by tyrant13

How many cc is the stock injectors?

Boost I am driving a manual 1.6L. Say if i were to boost only to abt 7-8psi on stock internals with no added or modded injectors, will it works? Only with custom exhaust manifold, intercooler, turbine. Probably with SAFC to tune it. Can my ride take it for daily use? Wish to drive it for...

Means to set the fuel regulator to 10psi? which is 0.7bar approx? I had a fuel regulator gauge, and i set it to 2 bar??

Thanks, I found it. I even took out the whole TB so that i can access to the 2 screws. But... the screws are too tight! Its the screwdriver kinda screws... Which is very difficult to get it out. I couldnt get it out despite full strength... Any solutions? I installed back the TB and the prob...

where is this idle air control motor?? Is it the intake air sensor at the SRI pipe? I oni spray inside the throttle body and throttle manifold... So shouldnt be that... Where is this air control motor?? Thanks alot!

Idling problem Hi, i am a newbie here. Recently I open up my SRI and clean the throttle body with those carb cleaner spray. The response is better after the cleaning but there appears to have a prob. Sometimes after I release the accelerator, the RPM should be gng down to idling range ard...

Another black protege.

Guys, Wondering can my humble 1.6L car be bored to using 81mm honda pistons from 78mm pistons? Can the cylinder walls take it??

Exhaust size Hi all, I am totally new to this forum and driving a humble 1.6L 2001 protege. I intend to change my stock exhaust. Can anyone advise wats the size best for my car? Stock Current header piping size= 1.5" Current down pipe size= 1.3" I understand that too big will affect...

Exhaust size Hi all, I am totally new to this forum and driving a humble 1.6L 2001 protege. I intend to change my stock exhaust. Can anyone advise wats the size best for my car? Stock Current header piping size= 1.5" Current down pipe size= 1.3" I understand that too big will affect...