Recent content by SxySpd3

Anyone in the CT/MA area have a stock downpipe for an MS3 I could pick up locally....cheap?? Looking for one asap...

diameter of the pipe thanks swampass

Does anyone know the stock downpipe diameter on the speed3?

I was thinking about putting a QTP cutout on my ms3, does anyone have it on an ms3 already? If so, have you seen much improvement? Does anyone know the diameter of the stock downpipe on the ms3?

Anyone know the stock downpipe diameter for the speed3?

Ms3 Ftw

I just put my injen cold air intake on a few days ago and it definately made a difference, and its sounds amazing! The stock BOV is soo much louder now.. I got the hydroshield pre filter for it because I drive my MS3 daily and live in CT ((we get alot of rain)) I was thinking about getting the...

same here, only issue is 3rd gear so it makes no sense with the timing suggestion. i think its an issue with 3rd gear it self, and with 900 miles on the car it just pisses me off

this really sucks, a brand new car should not grind even off rev limiter. i shouldn't have to shift it at 5k rpms...

952 miles as of today

mine grinds 3rd gear nearly everytime when i shift at high rpms. every other gear is fine, don't understand it. i put on the trz mm and it didn't help it out

where can you purchase the solid rear mount?

yeah i found it searching through the forums. i know i can do it without out a diagram, i just haven't had the time to look under the car yet. just got it and its still cold here in CT

anbody have a diagram of where the drain and fill plugs are?

did you log the run before it shows "knock"? if the a/f is consistent 10:1 then its not pulling timing and knocking