Recent content by Stupiddumbface

  1. S

    WTS: CPE CP-E Standback for Mazdaspeed 6 MSPD6

    The harness is plug and play? Ill take it pending some info digging on this.
  2. S

    Custom FMIC

    Where did you get the brackets? Also do you have a link to the IC you purchased? Fitment is awesome! Have you had an issues with couplers popping off after you cut the piping? Very Nice looking install!
  3. S

    Where to find short ram intake pipe

    Driver311 from Boise Idaho?
  4. S

    FS: Cobb Accessport for mazdaspeed 3 or 6

    I dont know much about these but I am assuming you have to enter a vin before it will "link" or something like that. So by uninstalling you mean that it is ready to plug and play basically? Do the maps cost money to down load?
  5. S

    Import Tuner Mag MS6 testing

    That was BY FAR the most abstract automotive answer EVER! Holy f_ck I am laughing so hard!(rofl)
  6. S

    Import Tuner Mag MS6 testing

    Sorry for the newb question but what do you mean by TIP? In SRT4 lingo it was a sensor...I am guessing TIP=Turbo Inlet Pipe for these cars?
  7. S

    disappointed with 1/4 mile times...ideas?

    I WOT shifted through every gear. It is consistant in thed 14.4 range. I will wait until it cools down a little bit and take it out again. I pulled the passanger seat and removed the spare...still ran a 14.4x. Its consistant as hell, but irritating at the same time.
  8. S

    Import Tuner Mag MS6 testing

    The numbers the showed from the CAI install were unreal! I was very impressed with that
  9. S

    disappointed with 1/4 mile times...ideas?

    Yeah the cat back is stock...I cant come up with the extra cash to dump on a exhaust system. Is there any similarity between the Speed6 and the regular 6 dual exhaust? The rear section in paticular.
  10. S

    Import Tuner Mag MS6 testing

    I just bought it...it claims 168 at the wheels not 118
  11. S

    disappointed with 1/4 mile times...ideas?

    I am at roughly 4200' above sea level. so I guess my 14.4 isnt to bad then. I tried riding out 4th gear, but that definately did not help, that yeilded a 14.9. It was almost 100 degrees out that day as well. Temps on the track were over the 100 mark. from the sounds of it I really shouldnt be...
  12. S

    disappointed with 1/4 mile times...ideas?

    There we go. I am shifting at 5800ish, what/who is AP. I will search the full throttle flash. Did ytou have this flash done when you trapped those speeds? I understand that R/T has nothing to do with 1/4 mile time...its the time you leave the staging area till you cross that matters. I didnt...
  13. S

    disappointed with 1/4 mile times...ideas?

    Driver "Mod" is just fine...but thanks. Here is the slip from the best pass R/T .007 60' 1.977 330 5.931 1/8 9.210 MPH 75.06 1000 12.025 1/4 14.407 MPH 94.87
  14. S

    disappointed with 1/4 mile times...ideas?

    The turbo isnt capable of supporting a 12? I managed a 12.9 in an SRT-4 with nothing more than a boost controller, FMIC upgrade, exhaust work and slicks... I would have expected this to at least be comparable. I have removed both cats, but I have not replaced the turbo inlet...I guess thats the...
  15. S

    disappointed with 1/4 mile times...ideas?

    I took my 06 MS6 to the track a couple weekends ago. The car ran consistant 14.4's and 1.9 60' times.... but I honestly expected alot more out of it. I ran it just after buying it, it was stock, and it ran almost identical times. Since I have added a 3" DP (no cats) and a CAI...which is not...
Back