Recent content by str8tupice06

i was looking for anybody who may have any knowledge about putting in angel eyes on my headlights for a 2006 mazda 3. i'm in boca raton but i don't mind driving if somebody or someone they know is willing to do it.

Alrighty then... may have to scratch that one, unless I just happen to be making a trip down there. In your free time, if u happen to speak to anyone that does the same installation near the Boca Raton area, feel free to let me know. Thanks anyhow!

I'm located about 20 minutes west of FAU Boca Raton Campus; right around the intersection of Glades and 441. I'm willing to make the trip depending on where you're located. If its to far, I'll see the next time I would be heading to your location, and perhaps I could meet you there.

I have the Angel Eyes all ready to go, but the guy who was originally going to do them was worried about screwing up the light. Hey Laraw, would you be willing to do mine and how much would it run? I would do it but I have no idea what I'm doing when it comes to installing them...

I got if the intake off of ebay. I can double check to see what the brand was. --> LARAW, I was looking at some of those picture from the meet that you guys had and I saw that you had the Angels Eyes Installed on yours. Did you do those yourself, or did you have somebody else do them for you?

I have a 2006 Mazda 3. I put a cold air intake on my car. My problem is that when I floor it, my engine service light comes on. I'm guessing that it is not used to the intake and is reading too much air, whereby turning on the service light. Is their a chip that I should use to make this...

I'm new to the site and was unsure who I should or could be asking. I recently bought angel eyes for my Mazda 3, and a guy who has worked on my car before felt uncomfortable with installing them due to a fear that they would not seal up or that the plastic was going to break with installing...