Recent content by squirrelmincer

Well the fenders need to be a bit wider to fit wider tires/ more offset. i was going to open the rear of the panel up to remove air from the fender-well. Need to make a patch panel were the sun roof was.... Most of the work would be to improve aerodynamics. Front spliter, flat bottom, side...

Ya sure did. Motor is built and swapped in a 6-speed from a speed. Found the limits of the stock ecu with dynotronics/aem fic piggy back. anything above 14 psi car no like. but it did make 340 torques. This past fall I was at SEMA for work and meet up with the guys at AEM. They were cool...

Whats up strangers?

I swapped in a 2010 speed trans.

Trans and axles are sold!

Time to clean out the garage! http://www.mazdas247.com/forum/showthread.php?123805951-Mazda-3-5-Speed-Transmission-and-more!

Cool, that makes sense. Keep us posted.

2007 Mazda 3 5 speed transmission, half shafts, and cables. Works like new, no pop outs or grinds. Redline MT-90 was used, changed twice. No signs of wear. 43,xxx miles on parts. Prices do not reflect shipping. Will discount as a package. Transmission $500 Half Shafts $60 each...

crickets.......

http://jalopnik.com/5851808/teenager-in-mazdaspeed3-sticks-the-landing

I was on NASA's web page, and they have a HPDE scheduled for 17-19 at VIR. Is that what this is?

Does it have a anti theft system?

We are in. 100% :)

I have a five speed trans sitting on my garage floor.......... with cables and shifter....... make me an offer So 300 pages have gone by. What did I miss?

I have two items for sale that are no longer needed. Car has a turbo now..... The intake has been rattle caned satin black. It is not perfect, but looks good. Filter was replaced this spring with a AEM dry-flow. This filter needs no oil= no messing up MAF sensor. Just wash and reuse. The...