Recent content by Moofknock

I agree. It's ok(ish) leaving it that way. It does look good and golds the key (clip broke and I don't have the money to replace it). It matches my red Mazda2 :)

I found this on eBay or Amazon: It looks great and covers it tight enough, except where the key unfolds on the side. Is there any non permanent glue to to keep it secured on that side? I mean, it stays inside the cover, I just like to have it fully covered on the key part. -Moofknock

Hi people! I just got a new shift mob for my 2011 Mazda 2 based on Transformers: I had to add a few rubber washers to raise the boot adapter to touch the bottom of the knob because it does leave a 1/4" gap in between: before after I love it, and it looks great!

Its fine, I managed to pull it. It is hard, but possible. I got the washers in, and my shift knob is perfect. Thank you!

The Matrix reference, Morpheus. :)

When you mean the front, we're talking about the rounded part? Do we pull upwards or back. Just wondering if the clips connect by sliding or just pushing/pulling upwards.

Ok, so it is not the silver ring that I need to pull but the whole thing with the black plastic that surrounds the boot and the silver plastic ring, right? I saw some photos and I think I can do this now :) Thanks Morpheus. Keep offering that red pill around!

Hi, First time poster. :) I purchased a new shift knot and there is a 1/4" gap between the bottom of the knob and the top of the shift boot. I want to be able to close that gap, and I understand the plastic ring that connects to the plastic console can be pulled, but I attempted that but...