Recent content by MazdaCurtis911

Ok I had water go into my cold air intake...but b4 this happened I LOVED the sound it added tto my car went great with my magnaflow exhaust..it gave it a lower sound and it sounded good all the way up the rev limiter :) but then water got into it..and I bought a prefilter which is just a cover...

Ok I have a question..how do you wire stuff to your car usually? dont you have to find a fuse and then stick the wire in and then push the fuse over the wire? and then take the ground wire and drill a hole in the chassi somewhere and use a krimp thingy and bolt it on?? like could I put a CB...

o yeah... also maybe it wasnt a problem with water getting sucked in? bc I got in my car and the check engine light was on..but then I checked the filter and the filter was pretty mnuch off... the clam slid off of the filter so maybe its bc there was an air leak? maybe????? hmmm I tightened it...

I just put on an Injen Cold Air Intake on my car and today it was raining all day..I was driving all day in it..and then later in the night I went out to start my car and it was running real rough and smoke was coming out of the exhaust reallly thick white smoke...and I couldnt rev the engine...

Found it! I found the fuse box...so on a 2004 Mazda 3 S the fuse box is under theglove box.

Ok so I have a 2004 Mazda 3 S and I cannot find the fuse box anywhere..I found the one under the hood but I need the one for the radio and all that stuff PLEASE help!!! Thanks :)

hrmm I think there is only one way to install that MAF sensor... I dont think its possible to have it backwards or anything

Ok so I bought an autozone plastic piping intake..I hooked the mass air flow sensor up to it but I put a breather where that cable comes out of the motor instead of hooking it back up..I tried to start my car and it just kept stalling..so I took the mass air flow sensor out and then the car...