Recent content by mattgotthefd

I'll keep that in mind. I actually just raised the car back up too.

It would have been easier to cut them off haha. I wish i would have had t-handle allen wrenches too my hand hurts like hell today. plus one of the 14mm nuts on the endlink was stripped as hell.

haha for sure.

Didn't even cross my mind yesterday but I'll remeber that.

i hit it with an impact until the it started turning but I'll check it again .

justanothermp5 i just found another thread about the endlinks. thanks again for the quick reply.

my vote will be in when the time comes.

Ill double check them i know they were as tight as i could get them. but yeah it is a clunking sound. the endlinks are cheap enough should i just buy new ones?

ok this one is a little hard to describe. I put the new struts on along with some stock springs last night and there is a sound coming from the rear. while driving it sounds kinda like the strut is hitting against the strut tower as if it werent tightened down all the way even though it is. i...

that looks great

wish i could find the pics. 1960 chevy apache 1988 ford crown victoria. I will definitely be getting another one of these one day. feels like your driving on clouds haha. current dd 1993 mazda rx-7

i used some cheap little light restoration pads my roomate had. i was gonna do it the same way you did but with 1500 or 2000 grit paper. the cars is actually my brothers so I'm not too worried about it. lol

just installed mine today and i wish i would have thought of that ^.

Forgot to take a driver side before picture but they both looked like this... and now.......

cleaned up the headlights and installed the HID's. Struts tomorrow!