Recent content by matt8679

Just passing what the dealer said!

This is what one of the guys told me at the dealership. Take the car out and bring it to operating temp. Then let the car sit at idle for 5 to 10 min. rev the engine a few time after it has been sitting and if you see blue smoke you may have a bad seal.

http://www.in.gov/dfi/education/warranties.htm This web page explains your rights. read Vehicle Dealers Obligations on this page. Also explains your right when you go to court. Hope this helps.

POWERTRAIN is 60,000 miles

This is off the cobb web page. Agile Automotive AccessTUNER/Dealer 2315 Bel Air Rd Suite C1 Fallston, MD 21047 (410) 877-3003 Phone www.agileauto.com Atlantic Motorsports AccessTUNER 8001 Queenair Dr. Gaithersburg, MD 20879 (888) 267-1788 Phone www.amstuning.com/atlantic...

Yes I have a speed3. To put the hydroshield on I just turned the wheel as far as it would go to the right. I then took out the plastic screws in the wheel well and i think there is three under the bumper i took off. you can then pull the wheel well back and put the hydroshield on. i also do this...

I had the same problem when i first got my Injen intake. It rained really hard the night before and on my way to work i experienced the same thing. Water was dripping on the filter. I took the intake off to check for water sitting at the bottom of the tube and there was a good amount. So i dried...