Recent content by jozi-111

FL-22 Engine Coolant. Change it every 12 years :)

When car is in regen mode, istop will not function, and I personally always monitor current consumption, when consumption goes up for 10-20 % without any reason then car is in regen mode and I try not to shut it down before regen is finished. I have been doing so for last 1000 km since I have...

I have repaired that seat clicking noise on my cx5 . Each seat has 4 springs under its cushion, these springs have near their latch point some rubber, but this rubber is so thin and it gets ruined (after one week of driving new car) and then spring is making contact with metal construction of...

Mazda uses special DPF oil so small amount of diesel should not harm lubrication ability of it. But I don't know what could happen if you drive with bigger amount like 15-20% of diesel in oil?!

It is funny how some people think that higher placed x mark has solved their oil dilution problem! :)

serpentine belt tensioner ;)

It goes to wastegate actuator. Becaose it is disconected you are running only wastegate spring 10 psi of boost!

Thanks for advise coyfish and Forzda 1. Coyfish you have forge bpv, I am thinking to buy one. Do you fell any diference to stock bpv in boost hold? And for my cai I made self some hydroshield (saw on forum similar) from water repellent textile and placed it between tyre and air filter to close...

When I was installing fujita air filter i couldnt put it on the botom of the pipe becoase down under is some kind of oil cooler for servo i think (on attached image). I managed today to put filter 3 inches lower, but it is now very near to the oil cooler. I will also attach some datalog from...

I own the car from beginning, but gauge and obdscope i have last four week. Fujita is installed 20 days ago. I will check filter, it might be too far up on pipe. Thnx

I have stock 06 mazda 6 mps (mazdaspeed6) with fujita cai. On my Nokia N97 i installed obd2 scope with wireless obd2 module conected to car, and i have racetech electronic boost gauge in center vent. I am not getting near to claimed 15,6 psi. Intake manifold pressure in first and secon gear...