Recent content by jitters

Great info. Thanks for the write-up. What size tire are you running? Are you rubbing ( with a +35 offset ), did you roll your fenders?

Are the 5mm spacers necessary? What is the offset of the wheels?

Thanks for replying. I forgot about the AAC kit, and couldn't figure out how you were able to get the rears to fit.

Do you have any rubbing? I didn't think Protege's could run a 235 with a +40 offset. I've wanted to run 235's with a 40 offset for awhile but was always under the impression that they would rub ( unless you run a lot of camber ). Car looks great. I love the MS-01's but I've only seen them...

Any chance you remember what 626 ball joints you purchased? In the protege service manual it says to replace the whole front control arm if the ball joint is worn.

Interested in the seats complete with brackets, but would like a couple more pictures. Can I get a pic of the Passenger seat bottom and the reclining mechanisms of both seats? Also you show the release mechanism on one of the seats, is it broken? Are they both broken? Thanks.

This manifold looks good. But it looks like it's going to be tough to install. How will you get access to the lower middle bolt?

What didn't you like about the Exedy? I've only read good things about the stage 1.

odie84 your pictures don't work. Any chance of you re-uploading them? I would be interested in how your downpipe turned out.

Money sent for the coolant hoses. Thanks.

How much for both coolant hoses shipped to 98230?

I received the refund. Sorry if I misunderstood. Did you sell the Microtech?

Money sent for the Microtech.

How much for the trailing arms shipped to 98230? Any pic's?

If BlkWidow doesn't take the radiator, I'm also interested in the radiator. Shipping to 98230