Recent content by jc4jax

  1. J

    timing belt/no start issue

    Things worked out, thanks all for the help and guidance. One thing did occur, after driving around the block everything seemed to work fine, but pulling into the driveway when I let the car decelerate the engine starting to sputter and the dashboard lights went out and it the CEL came on. I...
  2. J

    timing belt/no start issue

    Okay I got the cams to be aligned, but the crankshaft was slightly to the right of the mark. I reinstalled the spark plugs, valve cover, and connections. The engine started! Now I am wondering if I am off the mark how rough of an idle would the idle be to indicate it was off? The car is on jack...
  3. J

    Are these cars really this slow?

    At 3K rpm I am generally at 68mph. 2003 Protege LX auto.
  4. IMG_20101209_154515.jpg

    IMG_20101209_154515.jpg

  5. IMG_20101209_154515.jpg

    IMG_20101209_154515.jpg

  6. J

    timing belt/no start issue

    I got the battery replaced since it was still under warranty. The crank is much stronger and you can feel the engine jump a little in the mounts but no start. The angle of the camera was downward as I couldn't get the camera to take a clear picture if it was too close to the lens and the body...
  7. J

    timing belt/no start issue

    Okay I lined up the u-shaped mark on the back plate of the crankshaft to the engine block mark I aligned the cams again and re-installed the timing belt I tried to start the engine but no go. Thing is when I turned the key now it sounds like it is really struggling. The odometer blinks out...
  8. P1010330.JPG

    P1010330.JPG

  9. P1010328.JPG

    P1010328.JPG

  10. J

    timing belt/no start issue

    Thank you, I really appreciate the help.
  11. J

    timing belt/no start issue

    Cps I reinstalled the top cam position sensors as seen in these pics. However I did not remove the bottom position sensor, I was just very careful removing the pulley. I am open to suggestions as what to check next. Of note, the starter does sound tired when I try to start the engine. It seem...
  12. P1010324.JPG

    P1010324.JPG

  13. P1010323.JPG

    P1010323.JPG

  14. J

    timing belt/no start issue

    I am attempting to replace my timing belt and water pump and and v-belts. I got the water pump installed and I was having a tough time with the timing belt. The first time it had a rough start so I knew it was not set right. I re-did it and thought I had it right, I even stuck a dowel in the 1st...
  15. P1010316.JPG

    P1010316.JPG

Back