Recent content by J_Naoto

  1. J

    you CAN blow the welds on your intake manifold

    2019 update: i got the manifold back from rich (505) in december of 2013. a year or two ago, i noticed i wasn't peaking 26.5 psi anymore. did a boost leak test and the car was barely holding half a psi, but i didn't see anything obvious. used a smoke leak detector and found this. not sure...
  2. Snapseed.jpg

    Snapseed.jpg

  3. IMG_3596.JPG

    IMG_3596.JPG

  4. IMG_1796.JPG

    IMG_1796.JPG

  5. IMG_1794.JPG

    IMG_1794.JPG

  6. IMG_3128.JPG

    IMG_3128.JPG

  7. J

    WTB: ecu n/a mt

    looking for an ecu, part number FS8L-18888-C
  8. J

    Fresh Sweet Donuts Everywhere! (work log)

    i see a waste of good donuts.
  9. J

    2015 Tudor Schedules

    (thumb) looking forward to vir again!
  10. J

    Mazdas247 Mazda of the Month | August

    thanks, i got it in a group buy on this forum. there's a third group buy going on now. thanks!
  11. J

    Mazdas247 Mazda of the Month | August

    i have 205/40s all around. the rear is stretched more than the front due to different tires, rear fenders are rolled and front is cut near the bumper tabs.
  12. J

    Mazdas247 Mazda of the Month | August

    thanks everyone!
  13. J

    Mazda of the Month | ENTER NOW for August!

    J_Naoto Jason 2002.5 Proteg LX Garrett GT2871R Wiseco pistons Pauter rods Cometic MLS head gasket ARP main & head studs Clevite bearings Split Second FTC1 J&S Safeguard DeatschWerks 600cc injectors ATX to MTX swap PAR straight cut 3rd & 4th gears SPEC stage 3+ clutch Fidanza 7.5 lb...
Back