Recent content by infekted0rider

Well i have a Dyno shop who is gonna tune it but i just need the software to give it to them

I have a unichip and need to get it tuned but i dont live close to a unichip tuner so i need to download a tuner program from online. Anyone know where i can find a place to download the software or what software is needed? Thanks for any advice,

Yea it has the factory WGA but i never heard a whistle sound but its almost at 70k miles

NO i dont have a wideband O2 sensor

My MSP has a cold air intake and a Unichip installed into. The intake is about two years old and the chip is about a year old now. About 3 months ago i started haven problems when the car is driven with a cold engine it feels like it stops giving gas to the car and looses RPMs after you shif it...

Yea i check along time for one and looked online but couldnt find one. I didnt know if there was a way to make one, and thanks for looking stuff up.

Yes you can hear call when the radio is on standby but then there is no way to control the volume.

Tried pause it stops all sound to the speakers then but i can't pause radio stations anyway.

I just installed a parrat hand free cell phone kit into my car. It hard wires itself into the stereo system. I can hear people talk and everthing works correctly but i could not find a mute wire on the stock stereo sytem. Does any one know where the mute wire is or how to mute the stereo so that...

Thanks that is kinda where i was looking for the flywheel cuz i have heard good things about both.

So this weeked my clutch went out and this is my first clutch i have gone through. I was looking into Spec clutches. I dont have to much done to the MSP yet just CAI and chip. I plan on doing alot more to it so i was wondering Does it matter what stage of spec clutch i use or what is the...

I am trying to pass emissions and my check engine light is on because of my mass flow sensor is reading high voltage. I have an AEM cold air intake installed and i believe that is what is causing the problem. What can I do to fix this with out taking out my intake?

I had to splice into it but the check engine light came on right on after i installed it with the p0138 code. Do you think removing it long enough for me to get y emissions passed would work? Or is there a way to reset the computer to recognize the gauge?

I have installed a air/fuel gauge into my car. I am trying to get passed my emissions but P0138 is stopping me. It first showed up after I installed the gauge so if I disconnect the gauge will that most likely stop the problem?