Wow. This is exactly what I experience in my 2006 Maxda5 automatic. It ends to happen under 2 circumstances.
1, When I come to a stop, typically when the engine is cold (first 15 minutes).
2. when the engine is under very light load regardless of speed. I often hear it when cruise control is...
olddaddy, you were correct. After removing the screws you need to get a firm grip at the top and bottom of the housing and pull straight away from the vehicle. There are two plastic cones (I'm sure there is a proper term for them) that fit into holes on the body. They fit very tightly and...
I have a 2006 Mazda5. I need to replace the brake light bulb. I have removed the two screws but cannot get the tali light assembly to pull away from the body. I've tried pushing up, pushing down, rocking back and forth. I don't want to break it. It feels like something else is holding it in...
I ordered the "I-series". It's 3.5" and rated slightly better for reception. Until I get a direct mini-plug connection for my iPhone and XM radio I will be relying on the radio. I'm thinking of this...
The part that broke off was bent at a sharp angle and couldn't be removed. I believe it damaged the base. Darn garage door came down on it while backing up. Even scratched the roof a bit.
Here's how to replace the antenna base on Mazda5
I did this today. Took about 45 minutes but by following my instructions and photos it should take much less. The only tool you need other than your hands is a wrench and possibly a shop light. Now that I have the base replaced I can get either a...
Thanks. I was looking at the rear section of the headliner and I think I will be able to lower it enough to replace the part without having to completely remove it. I plan on getting a stubby/short antenna to replace the long one that broke off.
I just snapped off the antenna on my 2006 Mazda5 backing out of my garage. A long antenna like that on top of a tall car is bad design. I tried to unscrew what was left with pliers but could not. I just bought a new base ($80!) and I was hoping there was a way to replace it without removing the...