Recent content by fuzzybmx

Thanks for the reply guys! I've been searching the internet for pretty much weeks and a little bit here on the forms for a how-to with no luck. Thanks Chimmike for the link I'll check it out.

Hello everybody! I have a huge problem! My VVT pin feel out, which caused the bolt to dig into the side of the cylinder head of my engine. The car has 96,000 miles on it, so it's way out of warranty. I was wondering if anyone had a how-to full pulling the head off? Thanks for any help provided!

good morning everyone! its been a while since i have been on here. Well i got the turbo inlet pipe. and my problem seems to be better other than that fact i cant get the t-bolt clamp tight on the TIP. I would tighten it down then my car would see good boost. then I would check it and it would...

hey stealthyspeeder are you getting 11 psi for all gears? and you should be getting at least 15 psi. I bought a new cobb turbo inlet pipe and it seemed to help some. 1-3 gears seem better. And i thought the higher gears seemed better but as i drove more it seemed to lower back down. I replaced...

This a huge headache! i will show them instead of telling them. they have to be able to pin point something. cause really this is just not right!! Thanks again. also did you see my logs? could you tel anything by them? stealthyspeeder: good luck man! let us know.

I'm going to call them today. Thanks for the help man!

now i am noticing a sputtering when i am going WOT. im lost with that one.

here some logs from last night and this morning. I was in 3rd gear for all of them. I took off the intake cleaned everything. I took off the TIP, the vacuum hose going to the WG. everything looked good. I still need to double check the vacuum hose that goes to the BPV. i have not check the...

http://www.accessecu.com/accessport/mazda/AP-MAZ-002/How%20Mazda's%202.3L%20DISI%20Turbo%20Factory%20Boost%20Control%20System%20Works%20v1.00.pdf this a PDF file with info on the vacuum lines. my lines look good. I went and checked over all of them. I took my intake system off and cleaned it...

what do you mean where's my boost source?

oh that thing. I've taken it off and put that thing back on. and the rubber piece on it looks like it coming off or pulling away from the tube . its hard to explain. but I know it doesn't look right. but I plan on pulling it off and putting it back on with a another bracket to hold on it.

hey also what is a TIP?

thank you for the list! i will check in to these tonight after work. I really appreciate all your advice and help on this!

I did not check the intake before installing it. I've had it installed for over a year now. Ive had the AP for about 4 months now. but I will open it and take a look and all the piping. And no I have not install a turbo inlet pipe. but i will take that off and look as well. thanks again man!