Recent content by Foo2oo3

Thank you for your input. I'm going to go about getting a test fit on. Gotta find out who might do that.

07 Mazda3 S Touring No suspension upgrades. Wheel Diameter (Inches) - 18" Wheel Width (Inches) - 8" PCD Bolt Pattern - 5x114.3 Offset - 48mm Hub Bore - 67.1mm With 225/40/18?

Thanks for the input guys

Anybody currently have this or have any experience with it? I have seen it mentioned as an alternative to the more expensive signal processors like 3sixty and cleansweep. Are there any reviews or hands on experience with this that can shed some light on it for me?

Thanks for the tip

I don't believe it will sound like s***, and i don't like the dash kits for the aftermarkets. It would just be more money to buy a HU, Dash kit, pac swi for steering controls. I like the look of the factory headunit, and i am not going to any competitions with my stereo. So if adding a new amp...

Ok, thanks for the help.

yes but it only has one speaker output, for the subs only. So if i used the speaker level input would i just tap into the front speaker wire, or rear speaker wire, and then use the speaker output to run the subs? That way i wouldn't lose the use of any speakers so i just tap into the front or...

So for now just run a line out converter for the mono block amp for the subs, and then when i purchase the 4 channel amp with speaker level inputs just eliminate the loc and just run the speakers and the mono amp from the 4 channel amp with the pre out. Correct?

No i do not have the bose system.

Not sure if anyone will have the answer or not. I wanted to know if i purchased the audiocontrol lc6i if i could use it only to hook up my sub for now. My plan in the near future is to upgrade my door speaker with another amp, but i already have my subs and a mono block amp from my previous car...

No i was not planning on doing this myself. I was just wondering. In my old car, i had two amps powered by one power cable. They had the power hooked into one of the amps, and then ran another wire from that amp to the second amp. I figured they were sharing the same power. But anyways. Right...

I already have a mono block amp and subwoofers from my old vehicle, which i have not installed on my new mazda yet. I don't want to upgrade the head unit because i like the stock look, and i dont want to lose the little display with the temperature/clock/trip computer. What i want to do is...