Recent content by Fission

Been lurking for a while, but figured I can contribute something to close out this Memorial Day: 1) Installed a MS3 Rear Sway Bar, leaving the original endlinks on. Note for anyone considering: the bolt holes in the 1st gen MS3 RSB are a bit bigger than the stock 2010 MZ5 RSB (12mm? vs 10mm?)...

Late response: Sway bar arrived Thurs, just installed it an hour ago. Holes are a tad bigger than the stock MZ5, but there was more than enough surface area for the nuts to tighten down onto the bar and stock endlinks. Long term, I may get some MS3 endlinks, but I'll wait and listen for any odd...