Recent content by edangs

  1. E

    2006 mpv ABS and Brake light On with code C1175

    I did a scan and got abs code c1175 which is the driver side rear sensor. I traced out the line but the connector seems to be somewhere inside the wheel well. Anyone know how to replace this sensor?
  2. E

    2010 Mazda3 Car Insurance Premium Increasing?

    it has been exactly one year that i have owened my 2010 mazda3 iTouring. but my car insurance (no change, accident, etc.) has increased about 12% just after 1 year. so i asked my provider and responed with below: "The rating symbol for your 2010 Mazda has been revised. This caused a majority...
  3. E

    $1K market adjustment..any others out there?

    go on ebay ang get the car shipped for $500
  4. E

    2010 Mazda3 K&N Air Filter

    I've read report from other threads that Intakes has negative effects on the lower rpm's and only show the improvement at higher rpm (4k+) Ive opted to get the K&N filter because it shows the difference in the lower rpms (2k-4k) -which is where i spend most of the time.
  5. E

    2010 Mazda3 K&N Air Filter

    defenitely does not feel as 'choked up' -just look at the difference in thickness of the air filter. The drive is much better. the power at 2500rpm is noticable I have yet to confirm the improvement in gas mileage but people have reported good increase.
  6. E

    2010 SPEED3 burnt clutch?????!!!!!!

    i had my 2010 M3 itouring tranny replaced @ 1500 miles... all thanks to Ford! I miss Mazda.
  7. E

    2010 Mazda3 K&N Air Filter

    Just spreading the word that K&N Air filter (part# 33-2293) fits perfectly on our car
  8. E

    Grinding noise going from neutral to 5th

    i got the same prob on a 2010 M3, just got my car back and they ended up replacing the entire trans. i no longer get the grind from the same scenario.
  9. E

    5th Gear Grind on High Speed of 80mph above

    i got the car back and they ended up replacing the entire trans. i no longer get the grind from the same scenario.
  10. E

    5th Gear Grind on High Speed of 80mph above

    Dealer finally finished the replacement of the 5th gear and synchros and guess what...... problem is still there. dealer is awaiting instructions from, now, MAZDAJapan. It has been 10days and counting. 10 more days and i can file for lemon. Any transmission specialist out there that can...
  11. E

    5th Gear Grind on High Speed of 80mph above

    The car is a 2010 model with 650 miles. im sure anyone would be looney if they are in my position. i just spent 20k and i have to go through this and more importantly, who knows how this tranny is now gonna be down the road.
  12. E

    5th Gear Grind on High Speed of 80mph above

    Manufacturer finally looked at the car and confirmed that the 5th gear and the synchros will need to be relpaced. I would have preferred they replace the car, but that does not seem it will happen. Anyone have suggestions on how i can insist on the dealer or manufacturer to replace the car?
  13. E

    5th Gear Grind on High Speed of 80mph above

    I just came back from the dealer. apparently, there is something wrong with the car. the dealer tested the same scenario with another similar car and could not replacate the problem. I then test drove my car with the service director to confirm the problem. He will file the report to mazdausa...
  14. E

    2010 Mazda3 Gas Mileage Roll Call...Please...

    i just got 2010 iTouring 2.0L manual. I have 2 bars left on my first tank from 250miles of city/highway driving. If i have to guestimate, i would get around 300 miles on my first tank. 300 miles / 14 gallons = 21miles/gallon Rather disappointing.
  15. E

    5th Gear Grind on High Speed of 80mph above

    I have a 2010 Mazda3 Touring with 250miles. I noticed that the 5th gear grinds on high gear. Heres what happens; going 80mph, i take it out of 5th gear and put it in neutral,wait till the RPM goes back to 1k , I then step on the clutch all the way and shift into 5th gear -this is when i get the...
Back