Recent content by cornut

Chris there is a black box about 3"x3" under your drivers dash by the foot controls and fuse box. That is the wireless/security box. To program remote, pull down box it is held up there by plastic ties. There is a button on the box. That button will progrxm the remotes. Turn ignition on than...

No takers Help

How in the world do I program my factory remotes for my LX Mazda protege. I've tried the ignition on off 3 times push the little black button 3 times nothing HELP PLease this is driving me crazy bought on ebay and lost the instructions to do it HELP(killit)

reply give that to me in laymen terms, thx

Update....Fixed by Another Mazda Dealer, TWo wires were stress broke as well as the MFS was bad, they fixed both ME Happy They are happy to fix as well as I tip the rep a thank you lunch. I rest this post with a happy ending thxs everyone for all you suggestion many were correct most were close...

Update 911 Well I put it back to stock the wires was not an issue, checked all that no change, I put it back to original to as close as I could it looks go but we will see took it to another dealer let me hold my breath....I dealer I first took it to called me and told me to pick it up the tech...

reply your wright on all points here.

read this!!! Get this they said they want me to pay them to put a 1500 dollar wire harness in it if thats the case, they are full of it, now everyone why is the battery light/Alt on than???

Update Went to dealer bought new MFS put on put new filter reset computer fired it up BAM...it's still runs the same no differnce. Called matt at Mazda dealer told him ok I bought new sensor installed it reset computer and battery light as well as engine light is still on and it drives like...

reply whats really bs is they want you to buy their sh%$ and rip you head off for a warranty.

reply Do you or anyone on here know how to reset the computer on this car?

reply I put it in the way it was it really looks good hoping they wouldn't say anything!

reply thats what the service advisor suggested, it is a pain in the rear 2 hours woth of work!

reply so sounds as if you had the same problem? Any suggestions about the battery/alt light on, is it same problem.

I installed cold air intake with 15 miles on my 05 SP2.3 Mazda 3, it now has 2400 miles on it, the car started jerking at a load at won't run correctly, took it in the dealership they called me and said they will not repair the car and not warrant the Mass Air Flow sensor sense I installed the...