Recent content by BlackModzda_

No, they are pretty good quality it seems. The fit could be a little better and I'm picky. Haha Anyone else looking at it probably wouldn't notice. But they look good on the car. And I'd like the signals to be a bit brighter in direct sunlight.

"BMW Style" LED tail lights '13 and up LED tail lights. Used for about a week. I will update with install pictures. $350 shipped List Date: 1/23/2015 For more info, click here to view the original listing: "BMW Style" LED tail lights -------------------------------------- On Sale For...

I can get some installed pictures tomorrow in the light. I'll give a pretty good deal and you don't have to wait for them from China.

Why remove to plastidip? Just tape of a small area around it then peel off plastidip around it once you're done.

Bought them and decided I didn't really like them on my car so I'm trying to sell. Used for about a week. Make me an offer. Same as these: http://www.ebay.com/itm/171527562562

I figured this was from how the skyactive charging system works. The alternator free wheels until deceleration...

My stock Geolanders have about 7k on them and I notice tons of road noise! Can't wait to get new wheels and tires.

On mine you pull back to go down a gear... forward to go up a gear. Completely opposite of how I think it should be. The way you describe yours it sounds different than mine. I want back to go up and forward to go down.

So looking at that wiring diagram could you swap the UP and Down wires to make it so you invert the Manuel shift mode? I really hate the current set up and want it inverted.

think I figured out what I am going to do. In the wiring diagram when the DRLs are on it runs a straight circuit through the left headlight and grounds through the right one. But when the highs are on it grounds through the DRL relay for Left and uses the same ground on the Right. So if I cut...

I got a similar question... How are the DRLs wired? Im looking to do a Bi-xeon retrofit on Non Tech headlights. I want the drls to work like normal but I need the High Beam circuit to control the solenoid on the projectors. I can unplug the DRL fuse and everything works the way I want but loose...