Recent content by AceNinja

So I also got a set and noticed that the edges on all of them are cut oddly. I took a blade and trimmed them up as when you look underneath, there is either a trim line or an overhang look but once you take a closer look on all the edges you will notice.

Cleaning it once a month is fine and using a damp light soap can bring any dirt or body grease to the surface and use a damp clean cloth to wipe off is really all you need. Using a brush is good only for stains that are heavy since as lip stick or mud.

i think if you could save some more and invest in the U3000 it would be more beneficial due to the rader sensor for both front and rear. also best to use it with the "thinkware connected" app which i think is great to have.

there will be wind noise around the A pillar depending on how strong the wind is and angles but other then that, no other wind noise that i know of.

The A-pillar is easy to remove only if you know how because it can be very tricky to place back in place but to take it apart you need to pull from the top till it pop out and the clip that is holding it in, you will need to twist it till it match with the insert slot for it to come out of place...

Now i have another forum that has info i might need. Thanks

So, I finally was able to put in the roof rack and in my opinion. I think the only part that is good is the rail itself as everything else is plastic. also the screw stick out a bit once fully mounted in place due to the roof rail gap is small. Tips: Assemble all the mounting brackets and lower...

I have never owned a CX-9 but did owned a CX-5 2017 which I have traded in for the CX-90. I thought about getting it at the time but couldn't find the need for it. The i-stop isn't bad and it doesn't disactivate anything besides the wireless charger. Also the I-stop wont engage if other things...

Glad I am able to help and I hope we can get that diagram as it will be very useful. Also for anyone that wanted to add a roof rack which I will be adding. I found this which is a great deal with the promo code I found. I will post an update once I add this on Friday. The next thing on my list...

I was told that the only way to update now is to bring the car back with the sd card which to me doesn't make sense but i will bring it in and let them know about the recall that is out on some car regarding the steering bolt that come loose and can be heard on low speed.

they are nice for the price with the amount of features but for me. its the reliability and parts falling apart. i had a family member that had a 2018 Hyundai with only 60k miles on it that had burning 1qt amount of oil at 5k miles. most of the interior was already wearing while my 2017 mazda at...

so the back up battery connect to all 3 wires with is const, acc and ground. i only need to connect the acc and ground to recharge the battery when i drive the car. with the radar sensor on my car and left parking for about 12 hours. it only took about 5 to 10 percent of the battery and get...

here is how it should be connected just in case. The F770 is my first dashcam that was hard wire with a cutoff of 12.3 and still has problems. After that, i got the backup battery and change the dashcam to the u1000 and never once i got a problem but the backup battery dead in 4 years but got it...

I understand but once it is connected the right way and ensure that your getting power base on the fuse tap kit as it should only receive voltage from one side as both of the other side is split. once goes to the ACC out and the other goes to the fuse box. it shouldnt jump to the other side...

The reason was because even when i have set my dashcam cutoff voltage. I notice my battery dead sooner which was about 3 and half year and had to get a replacement. there was also time that my battery would completely die and i wont be able to start the car. this happen on my 2017 cx5 when i got...