I am stuck on an oem 2010 Mazda5 auto start new install. Help.

ty
I am stuck on an oem 2010 MAZDA 5 auto start new install
the dealer sold me the newer version...
0000-8f-L82
darn bcm wiring is different!! lol
as well as the brake plug wiring.

Anyone have a good pin out for the bcm as well as the brake plug by the hood lever?
 
the dealer came through
at least with the wiring pin outs.
now how to get it out of valet mode?
i looked in the owners manual and did not see any mention of it..
any ideas?
 

Attachments

  • 2010mazdabrakecolors.jpg
    2010mazdabrakecolors.jpg
    88.7 KB · Views: 136
  • realdealmanualbodymod30pincolor.jpg
    realdealmanualbodymod30pincolor.jpg
    134.7 KB · Views: 130
  • realdealmanualbodymod30pinhornhood.jpg
    realdealmanualbodymod30pinhornhood.jpg
    87.5 KB · Views: 130
stuck again.
it is beeping 3 times then pause and one more beep and no start.
question, this is a 2010 5gt
so does the BLACK / YELLOW door ajar need to be connected for the auto start to work?

also there is a black / orange in the bcm new branch loom from the 0000-8F-L82
does this need to be connected? if so where?
this had the oem hood switch from the factory.
 
BUMP any mazda dealer techs in here?
i need to know on the oem mazda auto start what the tach sense wire needs for signal.
 
Back