AEM TruBoost Controller help

[mildsalsa]

Ive installed the AEM TruBoost set in my car, i have A50 and B60. ive adjusted both up and down and my max boost is only getting up to 8.25psi by pressing the highest boost, im trying to got up to 10psi, when i turned the buttons to off mode.... i gunned it and it spiked up to 14.8-15.1psi.... i was like wtf!!!! huge puff of smoke left behind and car didnt seem to know what to do.. I also have an innovate wideband and a ss afc v2. any1 care to share their thoughts?(sadbanana)

 

[MSP-2003.5]

bring it over and we'll figure it out

 

[satyr36]

eep... hope you didnt hurt anything (white smoke)

its not smoking still is it?

not sure on your issue - is that the same controller you had at MWMF?

 

[mildsalsa]

ya same controller, and no more smoke, just that one burst.

 

[MSP-2003.5]

We got his boost straightened out, but whenever he goes into boost, the car stumbles really bad. I'm thinking that the wastegate actuator could be bad. It appears to be stock, could be a stock replacement

 

[MSP-2003.5]

bump

 

[MSP-2003.5]

I rode in his car, I don't think there is internal damage done, but it didn't feel right when he went into boost. It was like it was pulsating/stumbling, but ran perfectly fine at any other time