I've managed to rip off the noise insulation now twice.
Anybody figure out a way to brace the insulation at the connect points? Looks like it gets pulled at the drain vent by snow / heavy rain drainage / puddles and then that rips at the connect point hole before breaking away.
I see another thread that this was changed from a similar plastic piece during the 2017 refresh for road noise reduction. Anybody know if it would be possible to layer the 2016 plastic (for durability) over the 2017 fiber (for noise reduction)?
Open to suggestions, thanks!
Anybody figure out a way to brace the insulation at the connect points? Looks like it gets pulled at the drain vent by snow / heavy rain drainage / puddles and then that rips at the connect point hole before breaking away.
I see another thread that this was changed from a similar plastic piece during the 2017 refresh for road noise reduction. Anybody know if it would be possible to layer the 2016 plastic (for durability) over the 2017 fiber (for noise reduction)?
Open to suggestions, thanks!