Hey all, I’m new here but I came for help.
I’m stumped I swapped a running motor out of my 07 Mazda 3 it was a 2.3 into my 04 Mazda 3 hatchback . I know everything was fine I drove the car daily before pulling the motor and even pulled it in the garage prior to pulling the motor. I used everything from the old car. Wiring harness and even ignition and key. I’m not getting spark. I know the fuel pump is priming I can hear it and the fuel rail is filled with gas. I changed the cam sensor and also changed the crank sensor. I’m getting codes p0037 and p0043. I’m stuck i need to get it finished I have work in 2 days, car is ready to go besides no spark. I bled the clutch and got all of my mounts done. Also there is a harness that broke but I rewired it back in . Not sure if maybe I did it wrong?
I’ll post a pic of it for you to see and tell me . All grounds are tight and on there no anti theft light also the old car was an auto this one is manual but that wouldn’t cause it not to have spark right? I bypassed the Neutral safety switch.
Any help would be greatly appreciated ):
I’m stumped I swapped a running motor out of my 07 Mazda 3 it was a 2.3 into my 04 Mazda 3 hatchback . I know everything was fine I drove the car daily before pulling the motor and even pulled it in the garage prior to pulling the motor. I used everything from the old car. Wiring harness and even ignition and key. I’m not getting spark. I know the fuel pump is priming I can hear it and the fuel rail is filled with gas. I changed the cam sensor and also changed the crank sensor. I’m getting codes p0037 and p0043. I’m stuck i need to get it finished I have work in 2 days, car is ready to go besides no spark. I bled the clutch and got all of my mounts done. Also there is a harness that broke but I rewired it back in . Not sure if maybe I did it wrong?
I’ll post a pic of it for you to see and tell me . All grounds are tight and on there no anti theft light also the old car was an auto this one is manual but that wouldn’t cause it not to have spark right? I bypassed the Neutral safety switch.
Any help would be greatly appreciated ):