Search results

Hi I have a 2010 Mazda 3 S 2.5L, will a rear sway bar from a MSP fit?

I searched and there isn't much info on it that I could find- I have a 2003 Protege - I think its a DX. No power locks/windows, MT, no Tach. My question is can I swap a cluster from a 2001-2003 protege with a Tachometer with no problems? Can I use an automatic transmission cluster? I pulled my...

Hello all- My battery light comes on when hitting higher rpms (accelerating onto highway etc.). I do not have a Tach so I do not know specifically what RPM. The pedal is pretty much on the floor and it mainly happens in 1st thru 3rd gear, sometimes 4th. What I have tried so far; 2 TWO...

Hi all and yes I have searched this forum before posting this thread; I have researched and ordered a 2001 Mazda Protege MP3 ecu / pcm (computer) part number FS9N-18-881 followed by either a B or C, the one I have on the way is from a 2001 mp3 Vivid Yellow and from what I understand it is one...

I was removing my rear transmission mount (driver side rear mount under intake manifold) - attempting to do it with the intake manifold still on the engine - I took out my battery, tube from throttle body to MAF, and the throttle body, and it gave me some nice working room to remove the two 10mm...

Hey all- my 2003 protege 5MT has thunk/shudder when accelerating from standstill from the front driver's side. I just replaced 3 motor/trans mounts (front by radiator, driver wheel, passenger wheel). The thunk/shudder I am getting when accelerating from a standstill/releasing clutch has...

***Duplicate please delete

I just bought a 2003 Mazda Protege DX Manual transmission 135k miles and have been having issues with rough idle. At emissions it threw a p0303 CEL light for cylinder 3 misfire. I noticed a small pool of oil near the #3 spark plug boot, took boot out, fair amount of oil on it as well as oil on...