Search results

  1. F

    2017~2024 Clunk on sharp turns with brand new CX-5

    This video will help you with your old CX 5 and newer CX 5. And other CX Model. Must use alot of spraying silicon grease on the LCA assy bore (large bushing) and knock it with some mallet or hammer to make sure it doesnt sticks. https://youtu.be/EfR6hGUnDO4
  2. F

    Driver side clunk (2016.5 CX-5)

    check this video hope it helps.
  3. F

    Driver side clunk (2016.5 CX-5)

    Check your Lower control arm large and small bushings https://youtu.be/9vxE28BfhP8 https://youtu.be/butRrfy8PkQ Mine was like this before : https://youtu.be/EfR6hGUnDO4 Hope this helps.
  4. F

    2013~2016 How to check battery health and the alternator on your CX-5

    Thank you sir for all the feedback. 🙏🏼🤓
  5. F

    2013~2016 How to check battery health and the alternator on your CX-5

    Hi guys, been awhile since I have not posted video. I'd like to share with you basic tip that anybody can do to their car or Mazda CX-5. How to check the health of your car battery and alternator using a multimeter. Basic and quick. https://youtu.be/YuLB9EbgU2g And i have added a Quick video...
  6. F

    2013~2016 CX-5 GT Front suspension noise troubleshooting

    Check your Lower control arm n ball joints. https://youtu.be/EfR6hGUnDO4 https://youtu.be/butRrfy8PkQ https://youtu.be/9vxE28BfhP8
  7. F

    2013~2016 Mazda CX-5 Front brake pad replacement service. Brembo OE

    Quick Update on the Prime Brembo brake pads. A good value for money pads for around $60 a pair , Great performance for daily & no squeeling sound. The only downside is they’re a very dusty brake pads so you might want to think about cleaning your rims every week or so...
  8. F

    2013~2016 CX-5 Automatic dimming rear view mirror replacement

    Do you have similar problems with automatic dimming rear view mirror. Mine had spots all around the mirror internally. Well lucky enough i have found replacement Used parts in a good condition. https://youtu.be/mBYZwBnEhDo
  9. F

    2013~2016 Mazda CX-5 Front brake pad replacement service. Brembo OE

    🫰🏼 I appreciate it . Thank you sir.
  10. F

    2013~2016 Mazda CX-5 Front brake pad replacement service. Brembo OE

    Thank you 😊 .Ohh yes the brembo comes only 1 shim. The old had 2 so i had to pull one from the old and add to the new one.
  11. F

    2013~2016 Mazda CX-5 Front brake pad replacement service. Brembo OE

    I'm just going to leave it here, just incase you want to do a brake maintenance job. https://youtu.be/f6SSQSgAj3c
  12. F

    Guide CX-5 Universal Oil Catch Can Installation

    Hi , just did another oil change 8000kms later. Checked my oil catch can and yes the oil catch can has capture some more oil similar to my old short videos and it works well capturing the unwanted oil vapours.
  13. F

    2013~2016 CX-5 Swaybar Polyurethane Bushing kit Install DIY

    Have you look thru Superpro Australia i think they have it for your mazda cx 5. But yes, you have to measure the diameter of the Sway bar.
  14. F

    2013~2016 CX-5 Swaybar Polyurethane Bushing kit Install DIY

    you welcome sir. Make sure to check my other CX 5 Vids 😁
  15. F

    2013~2016 CX-5 Swaybar Polyurethane Bushing kit Install DIY

    i went the hard way without removing the rear subframe, the correct way is lower the subframe for better access of the bushings bracket nuts. Lucky mine were not too difficult to remove the nuts just had to be extra patience as the space very tight.
  16. F

    2013~2016 CX-5 Swaybar Polyurethane Bushing kit Install DIY

    first impression after done some driving and cornering , steering response definitely are so much better than before, the car is just more planted down to the ground during hard cornering. very stable , very sporty feel not too harsh not too soft the car feel just about right. Its like a new car...
  17. F

    2013~2016 CX-5 Swaybar Polyurethane Bushing kit Install DIY

    https://youtu.be/Cgi56M5yPpA It was a very tight space to work with on this car. But managed to complete the install.
  18. F

    Click / Clunk / Knock sounds 2018 CX-5 AWD

    Super pro Australia does have the polyurethane bushing kit for our Mazda and available for many popular model vehicles.
  19. F

    Click / Clunk / Knock sounds 2018 CX-5 AWD

    ofcourse you can , but you got to have hydraulic press so the job will be alot easier. The easiet way is to replace whole. but you will find it much value and fun if you can replace each of the worn out bushing it self . 😀
  20. F

    2013~2016 Lower Control Arm Larger Bushing upgrade / replacement Mazda CX-5

    Ah yes forgot to mention you will need hudraulic press / bushing press tool for this job. otherwise it would be very hard to do. 👌👍
Back