Recent content by 323F Rock

Yeah I might knock up an intake at some point as well as getting an exhaust made :D

think it was a combination of low tyre pressure and pot holes (hand)

Thanks man, The multi spoke ones are Team Dynamics ProRace 1's (cant get them anymore closest equivalent is ProRace 1.2's) The 5 spoke ones are also Team Dynamics ProRace 3's :D

If there's a few of you, could you share postage? I can buy and pack for you guys :D

something like this? http://mazda-2.sgpetch.co.uk/pages/accessories/detail/model=375/category=ROOT-interior/accessory=Trunk+Liner/id=3412

323F Rock Nathan Stephens 1997 323F BA Engine: Original 1.5l engine 90BHP change to 1.8l BPD now at 275BHP - 205% power increase! Mazda 323 GTR 1.8L BPD Turbo engine IHI VJ23 Turbo RHF6 Tial F38 External Wastegate Apexi air filter (500-A026 -> replacement filter 500-A022) Grayson...

These do look good, Is the replacement arm they sell just a powder coated OEM one though? I highly doubt an after market company tooled up a pressing for the 2! If that's the case I might just buy the bushes and ball joints and press them into my standard control arms.

Bought some new parts :D AWR Rear engine mount - Fitted Corksport short shifter - not fitted yet Both of which were 2nd hand so nice and cheap! :D Also paid up for a ECU tune by Dynotronics :D And put my name down on a 4-2-1 hot pipes header but if the turbo kit from dynotronics comes out I...

I could quite easily as could most but the difficult thing is getting my 2 somewhere in the air to measure it out properly! plus the 323F is taking a lot of my time!

You look for a "Binx nut" We use them at work some times, its low profile all metal locking nut? :D

Your spot on! On other Mazdas there's a speedo sensor in there :)

tried that, I got a no :(

What's all this then? :D

I'm sure there's a way to turn that off I'll check my manuals

Nice!